WET SAND BLASTER KIT REMOVE GRAFFITI-STAINS-RUST & STRIP PAINT
USES DRY SILICA SAND OR #1 GRIT SAND MAX PRESSURE IS 3500 PSI
THIS WET SAND BLASTER KIT IS ESPECIALLY ADAPTED FOR THE
"BAR" BRAND OF PRESSURE CLEANERS, FROM 2000 PSI UPWARDS.
IT HAS A 1/4" QUICK RELEASE FITTING THAT CLIPS IN WHERE YOUR
NORMAL SPRAY CARBIDE NOZZLE SITS. IT HAS 8 METRES OF HOSE, WITH A SPEAR
ON THE END TO BE USED IN DRY SIFTED SAND.
THE FLOW RATE - 38 LITRES PER MINUTE MINIMUM FLOW 3.5 GPM TO MAXIMUM FLOW 10 GPM.
MAXIMUM PRESSURE - 3500PSI
INLET - 1/4" QUICK COUPLING MALE PLUG
NOZZLES AVAILABLE FOR THIS UNIT ARE 1.2MM DIAMETER AND 1.4MM DIAMETER
WET SAND BLASTING IS AN IDEAL WAY FOR CLEANING STEEL, BOAT HULLS, CAR BODIES, WALLS WITH PAINT; ANYTHING THAT A NORMAL SAND BLASTER WILL DO, A WET SAND BLASTER WILL DO. THE ONLY DISADVANTAGE WITH A WET SAND BLASTER IS THAT IF THE STEEL IS NOT DRIED STRAIGHT AWAY IT WILL GET A MILD SURFACE RUST VERY QUICKLY. IF IT IS CLEANED IN THE SUN WITH A BIT OF HEAT THIS WILL NOT HAPPEN.
THE ADVANTAGE OF A WET SAND BLASTER IS NO DUST. THE WET SAND THAT IT USES IS CONFINED TO A VERY SMALL AREA WHERE THE JOB IS. A MASK IS RECOMMENDED BUT NOT NEEDED ON SMALL JOBS.
THE SAND THAT YOU USE CAN EVEN BE CREEK SAND BUT MUST BE A MEDIUM MATERIAL. ALWAYS MAKE SURE SAND IS SIEVED BEFORE USE. BEFORE PUTTING IT IN A BUCKET AND PUSHING THE SPEAR (WHICH IS SUPPLIED) INTO THE SAND. THE WHOLE SYSTEM IS A VENTURIE ACTION AND YOU WILL BE EXTREMELY SUPPRISED ON HOW GOOD IT IS ESPECIALLY ON BOAT HULLS.
SUITS MOST PRESSURE CLEANERS
|